Waste oil lance UNIGRESS DDM/XL for kiln firing systems
The UNIGRESS DDM/XL oil lance series is designed as waste fuel oil lances using compressed air (or steam) for atomisation.
The design allows to burn liquid waste fuels with high or low viscosities, with or without solid particles. The lance is used in rotary kiln or calciner burners.
Waste oil is supplied via a central pipe which is surrounded by an outer pipe for compressed air feeding (alternatively steam). Oil flows straight through one single nozzle-bore designed with a minimum diameter of 6 mm. Compressed air (or steam) is injected through bores at a conical part of the nozzle for atomisation.
The control range depends on the speed controlled pump installation.
This special design has no internal parts.
Therefore oil contaminated with solid particles
can be fired without risk of blocking.
Low wear and low pressure losses are
additional design benefits.
Main characteristics are:
- Bores for fuel atomising
- Straight nozzle-bore to prevent particle blocking
|UNIGRESS DDM/XL||DDM/XL 1||DDM/XL 2||DDM/XL 3|
|Max. flow in kg/hr||2000||4000||8000|
|Max. flow in lb/hr||4400||8800||17600|
|Lance carrier pipe Ø||60,3 mm/2”||76,1 mm/2,5”||88,9 mm/3”|
|Waste oil pressure||2 - 4 bar / 30 psi - 60 psi|
|Compressed air||4 - 6 bar / 60 psi - 90 psi|
|Compressed air flow||7% - 11% referred to oil mass flow|
|Particle size||3 - 4 mm/0.15 inch|
|Atomising viscosity||up to 120 cSt|
Above flows refer to oil with a specific weight of water.
For aggressive media the UNIGRESS DDM/XL lance is available in stainless steel.